Aztech HellFire V2 polymer Hop Up

Description

Key features

• Thread the Hellfire in a reverse direct until threaded all the way on(maximum of 12mm) making sure to be careful that the inner barrel doesn't make contact with the rear of the internal tongue. If it does make contact, unwind the hop until it has clearance
• It more than likely will not have perfect rotation alignment toset the hopramp at 12 o'clock
• Rotate to set the alignment correctly then use the side grub screws to hold the Hellfire firmly in the correct position
• To adjust the hop up, Turn the slotted end cap to lower the hop ramp, the cap rotates just 90 degrees offering 8 settings
• If a permanent fixture we would recommend using a low strength loctite to hold the side grub screws in place and if you wish a small amount on the main thread from hop to out barrel
• Hellfire!!!!!!
• Muzzle brake styling to enhance your blaster both visually and performance wise
• This version has many enhancements including inner barrel stabilisation and 180 degree of hopup level adjustments

Compatibility and requirements

• Confirm platform, model and generation compatibility; professional fitting may be required

Additional product details

Using the same internal design and technology asour long proven Muzzletek hop up that changed the face of gelball accuracy and range capabilities.

Now with the outstanding appearance to match the performance.

The Hellfire side ports disperse gases and vapor just like the real thing.

The Hellfire has Tool-less adjustment by turning the front face of the housing to apply more or less hop through a a now improved 180 degree adjustment rotation.

Before ordering: Compare the model, measurements and compatibility details with your existing equipment.